Bronkhorst CEM W-300B User Manual

Instruction manual C.E.M. Controlled Evaporator and Mixer W-300B Doc. no.: 9.17.082A Date: 10-06-2014 ATTENTION Please read this instruction manual

BRONKHORST HIGH-TECH B.V. 2.9 Electrical specifications 2.9.1 Functional diagram 2.9.2 Electrical specifications Heater The heater consists of

BRONKHORST HIGH-TECH B.V. 2.11 Supply pressure Do not apply pressure until electrical connections are made. When applying pressure to the system,

BRONKHORST HIGH-TECH B.V. 3 Operation 3.1 General The Bronkhorst HIGH-TECH B.V. CEM system is designed in such a way that it will meet user proce

BRONKHORST HIGH-TECH B.V. By 50% r.h., the (mole) ratio between gas and water: 100.%. ⋅=sateehr 6.2361003.47350=⋅=e [mbar] the mole

BRONKHORST HIGH-TECH B.V. 4 Readout and Control unit The use of standard readout unit, manufactured by Bronkhorst HIGH-TECH B.V. is recommended. 4

BRONKHORST HIGH-TECH B.V.

BRONKHORST HIGH-TECH B.V. 5 Cables 5.1 EMC and cables All system set-ups described in this manual carry the CE-mark. Therefore they have to compl

APPENDIX 1 Recommendations for handling the Bronkhorst High-Tech DLI (CEM) system Vacuum system Non Vacuum system

BRONKHORST HIGH-TECH B.V. 1

Startup using Vacuum A) To fill the system: Procedure: Actions: A1) Evacuate the lines “Vacuum” Start pumps A2) Evacuate all lines Close: 2,3,5

BRONKHORST HIGH-TECH B.V. page 2

BRONKHORST HIGH-TECH B.V. B) To start the process: Procedure: Actions: B1)Set the CEM heater at right temperature. Give setpoint to the heater, wa

Startup without using Vacuum Liquid4356810119MFCCarrierProcessgasVacuum7LFMInertgassupply2ProcessVacuumValveHeatedlineCEMLiquidGas A) To fill

BRONKHORST HIGH-TECH B.V. B) To start the process: Procedure: Actions: B1) Set the CEM heater at right temperature. Give setpoint to the heater,

APPENDIX 2 Enclosures (if applicable) Declaration on contamination Dimensional drawings Hook-up diagram 1

Even though care has been taken in the preparation and publication of the contents of this manual, we do not assume legal or other liability for any

BRONKHORST HIGH-TECH B.V. Safety Precautions The following safety precautions should be observed before using this product and any associated instru

BRONKHORST HIGH-TECH B.V. Short-Form Operation Instruction - Before installing your CEM system it is important to check: * flow rate * f

BRONKHORST HIGH-TECH B.V. TABLE OF CONTENTS 1 Introduction 1.1 General ...

BRONKHORST HIGH-TECH B.V. MixLiquidGasCONTROLLEDVAPORATOREMIXERControl valve assemblyPurge connectorLiquid-gas mixing deviceLiquidGasHeat exchangerPr

BRONKHORST HIGH-TECH B.V. 2 INSTALLATION 2.1 Receipt of equipment Check the outside packing box for damage incurred during shipment. Should the p

BRONKHORST HIGH-TECH B.V. 2.6 In-line filter Although fluids and piping should be absolutely free from dirt, it is recommended to install inline f